Tuesday, March 26, 2013

Servo repair with 4-40 tap, no thanks to silly proprietary servo hardware

Hexapod now has 18 working servos again! yay.

Servo Failure modes
I didn't strip the gears* on one of my servos from applying to much load to it (the way I expected my servo to fail), but rather stripped the threads on the servo to servo horn coupler.

*see http://techtv.mit.edu/videos/10523-what-is-design-an-example for a good video of designing a robot, having the gears strip, and solving that problem with rubber "shock absorbers." This video is shown near the very beginning of 2.007 Design and Manufacturing I, a sophomore build-robots mechanical engineering class.
@28:30 you see a good picture of stripped servos gears, where the missing teeth means that the servo can't turn correctly:

Anyway, I had some issues because I thought maybe I was using the wrong size screw. The servo horns and screws and splines are all some dumb not inter-compatible between manufacturers proprietary design.

So I ordered some replacement servos off of ebay.
"Vigor VS-2 standard analog Servo VS 2 vs2"
$9.98 for 2, or $4.99 each.
Probably I paid way too much but whatever. At the time I thought $5 was really cheap for a servo (now I think $3 is more reasonable price for this servo). Bought 2/9 and delivered 2/19, not bad.

At first I thought I got ripped off and the servos were stripped, but then I looked more closely and realize that there are no threads cut into the servos:


So you can use the proprietary self-tapping screws, but I realized you can just tap them with regular ol' 4-40 threads and use normal 4-40 screws instead of, if you ever lose the pack of proprietary servo stuff, hunting around for ages looking for an appropriate size screw.

left: 4-40 screw mates fine with servo horn. top: a 4-40 tap. right: A proprietary screw with mysterious thread count and pitch next to a nylon 4-40 screw.


Works well!

No comments:

Post a Comment